I think of section cut and it doesn't benefit anything much because they are pieces
instead of that can I do it like possibility of transforming objects?
I think it can explain more than section cut. or at least i should do as minimum requirement?
And i will do exploded axon tomorrow.
position now
final model > 40% (+straw weaving at 1:1 scale)
plate > 60+%
ps. i can not upload again
i will send them to your email then
i guess it's because of the size A0
it's about 3mb. + at low resolution .jpec
2 comments:
You could maybe mix section and axo - having the section cut all along, and the axo of the pieces above, related to the section.
Your plates are coming along well.
But be careful about your English writing - some sentences do not make sense!
plate 1 - the elevation is very minimal, or too abstract... You can surely show more of your project there!
plate 2 - English! + lines on plan views almost invisible, you can maybe use colour for the 1st 2 drawings as well
plate 3 - English! + the alignment of the different drawings does not make sense, we do not understand the relations (if they are the same elements or not)
Too bad you can't put them on the blog, would be nice for everyone to see.
thank you i will redo them
Post a Comment